OFM 509-LX - Manual

Model 509-LX
Encore Series Leatherette Guest Chair
Parts Listing
STOP
Assembly Instructions
Tools Needed: Allen Wrench
Please read all instructions before assembly.
Step 1: Attach Arm Rests (C) to sides of Chair Seat (B) using 6mm Screw (F).
Tighten with Allen Wrench.
Step 2: Attach Chair Back (A) to Arm Rests (C) using 6mm Screw (F).
Tighten with Allen Wrench.
Step 3: Attach assembled seat to Chair Base (D) using 6mm Screws (E)
and 6mm Washers (G).
Step 4: Cover screw holes with Screw Caps (H). Press in firmly.
B
Chair Seat
1 Unit
A
Chair Back
1 Unit
C
Arm Rests
2 Units
G
6mm Washer
4 Units
H
Screw Cap
8 Units
1
B
C
F
2
F
A
4
H
3
D
E
G
D
Chair Base
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
WEIGHT CAPACITY: 250 lbs.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
05.12.2014
I
Allen Wrench
1 Unit
E
6mm Hex
Long Screw
4 Units
F
6mm Hex
Short Screw
8 Units