OFM E1007 - Manual

Allen Wrench
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model E1007
WEIGHT CAPACITY: 250 lbs.
Parts Listing
STOP
Assembly Instructions
Tools Needed: Allen Wrench (provided)
Please read all instructions before assembly.
Step 1: Insert Casters (D) into bottom of Chair Base (C). Insert Gas Lift (G) into center hole
of Chair Base (C). Cover the Gas Lift (G) with the Telescopic Bellows (H).
Step 2: Attach the Seat Mechanism (F) to Chair Seat (B) using Screws (I). Tighten with Allen
Wrench (J).
Step 3: Attach Chair Seat (B) by inserting top of Gas Lift (G) into the hole in the center of the
Seat Mechanism (F). Press down firmly on the Chair Seat (B) to secure.
Step 4: Attach Chair Arms (E) to Chair Seat (B) using Screws (I). Tighten with Allen Wrench (J).
Step 5: Attach Chair Arms (E) to Chair Back (A) using Screws (I).Tighten with Allen Wrench (J).
Step 6: Pivot the Chair Back (A) up, then attach using remaining Screws (I).
Step 7: Place Arm Caps (K) into the arm holes once screws have been tightened.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
10.08.2012
A
Chair Back
1 Unit
B
Chair Seat
1 Unit
C
Chair Base
1 Unit
D
Casters
5 Units
E
Chair Arms
2 Units
F
Seat Mechanism
1 Unit
G
Gas Lift
1 Unit
H
I J
Arm Caps
8 Units
K
Screws
12 Units
1
H
G
C
D
Telescopic Bellows
1 Unit
2
F
I
B
B
3
4
E
B
E
I
6
I
A
B
5
I
A
B
7
K