OFM N101 - Manual

A
Seat
1 Unit
B
Base
1 Unit
C
Support Leg
1 Unit
D
Seat Bracket
1 Unit
E
Plastic Cap
1 Unit
F
8x25mm Screw
4 Units
G
8x30mm Screw
3 Units
H
8mm Nut
4 Units
I
Allen Wrench
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model N101
NET Swivel Chair
WEIGHT CAPACITY: 300 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
05.16.2012
G
STOP
Assembly Instructions
Tools Needed: Adjustable Wrench and supplied Allen Wrench
Please read all instructions before assembly.
Step 1: Attach Base (B) to Support Leg (C) by inserting
8x30mm Screw (G) up through the bottom of the
Base (B) into the Support Leg (C) using Allen
Wrench (I). Tighten securely.
Step 2: Attach Seat Bracket (D) to Seat (A) by aligning the
holes between the two. Now insert 8x25mm
Screws (F) under metal mesh of Seat (A) and down
through holes and Seat Bracket (D). Attach the
8mm Nuts (H) on the bottom of 8x25mm Screws (F).
Using the Allen Wrench (I), tighten all screws
securely only when all four have been attached.
Step 3: Cover 8x25mm Screws (F) under mesh with
Plastic Cap (E).
Step 4: Place Seat (A) with attached Seat Bracket (D) onto
the top of the Support Leg (C). Press down on
Seat (A) firmly to secure.
C
H
D
A
B
E
F