OFM 77366R - Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
06.30.2014
1
2 3
D
E
H
I
F
H
4
Parts Listing
Model 77366L / 77366R
Executive Series L-Shaped Pedestal Desk Return
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected] J
Phillips Head Screw Bit
1 Unit
A
Return Top
1 Unit
I
6x30mm Screw
4 Units
C
Pedestal
1 Unit
E
L-Shaped
Panel Mount
2 Units
G
Screw Cap
2 Units
Assembly Instructions
Please read all instructions before assembly. Assembly will require 2 people.
Tools Needed: Allen Wrench and Phillips Head Screw Bit
The following instructions should only be used following the assembly
of a 77366 desk.
Be sure to remove the Pedestal drawers prior to installation.
Step 1: Align Side Panel (B) on the underside of the Return Top (A) by
aligning screw hole brackets with holes in Return Top (A). Insert
6x16mm Screw (H) through Side Panel (B) bracket and into Return
Top (A). Tighten using Phillips Head Screw Bit (J) or screwdriver.
Step 2: Attach Pedestal (C) to underside of Return Top (A) by aligning screw
holes in Pedestal (C) with holes in Return Top (A), and inserting
6x16mm Screws (H) to secure. Attach Pedestal (C) to Side Panel (B)
by inserting 6x16mm Screws (H) through pedestal wall and into Side
Panel (B). Tighten using Phillips Head Screw Bit (J) or screwdriver.
Cover exposed holes in Pedestal (C) with Screw Cap (G).
Step 3: Attach L-Shaped Panel Mounts (E) to the underside of the Return Top (A). Align screw holes
in L-Shaped Panel Mounts (E) with holes in Return Top (A) and insert 6x30mm Screws (I)
to secure. Tighten using Phillips Head Screw Bit (J) or screwdriver. Slide Return Privacy
Panel (D) onto L-Shaped Panel Mounts (E) and attach by inserting 6x16mm Screws (H) to
secure. Tighten using Phillips Head Screw Bit (J) or screwdriver.
Step 4: Flip the return right side up using at least two people. Line up with the appropriate position
on 77366 Desk. Attach by inserting 6x16mm Screws (H) up through Return Support
Bracket (F) to secure to both the Return Top (A) and the 77366 Desk Top.
Note: At this time, insert drawers back into Pedestal (C) and push all the way in to secure.
H
6x16mm Screw
18 Units
F
Return
Support Bracket
1 Unit
D
Return
Privacy Panel
1 Unit
B
Side Panel
1 Unit
B
A
J
H
H
H
G
C
B
A A
C
D
STOP