OFM GT4794 - Manual

A
Table Top
1 Unit
B
Center Support Beam
1 Unit
C
Support Braces
2 Units
D
Legs
2 Sets
F
Leg Screws
18 Units
G
Mounting Stud
10 Units
Model GT4794
Glass Conference Table - 47” x 97”
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
07.11.2012
STOP
STOP
Assembly Instructions
Tools Needed: 7/32” Allen Wrench
*You will need at least 3 people to assemble this table. DO NOT attempt to
assemble by yourself.
Please read all instructions before assembly.
Step 1:
Using three people, very carefully lay the Table Top (A) upside
down on a flat, clean surface. Attach the Center Support Beam (B)
to the mounting plates on the Table Top (A) by inserting Support
Screws (E) through Center Support Beam (B) and Mounting Stud (G),
and into mounting plate. Repeat for other side.
Step 2: While one person holds up the Legs (D), attach the Legs (D) to the
mounting plates on the Table Top (A) by inserting Leg Screws (F)
through holes in the Legs (D) and into the Center Support Beam (B).
Please note that two go into the Support Beam (B) and one goes
into the Leg (D). Only hand tighten Screws (F). Repeat for other side.
Step 3: Secure Legs (D) by lining up Support Braces (C) with holes on
the Legs (D) as shown.
*Please make note of the distinction between the mounting holes
on the Support Braces (C). Two corners have a severe angle,
while one corner is less severe. The two matching corners should
attach to the Legs (D) as shown.
Attach by inserting Leg Screws (F) through Support Brace (C) and
into Legs (D). After attaching Support Braces (C) to both Legs (D)
on one side, line up remaing corner on Support Brace (C) with hole
on Center Support Beam (B) and attach by inserting Leg Screw (F)
through Support Brace (C) and into Center Support Beam (B).
Repeat for other side. Securely tighten all screws in table.
1
B
E
A
G
3
B
D
F
C
A
2
B
F
D
A
F
E
Support Screws
10 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
ATTENTION: After assembly, 3-4 people are
required to turn table right side up.
Total Weight of Table: 274 lbs.