Clickfree Backup Drive - Manual (Page 18)

Clickfree Backup Drive for Macintosh: User Guide Restoring my content
W HAT GETS RESTORED , AND TO WHERE ?
When Clickfree restore runs without you changing any options, it restores all of the
content that was backed up, and puts it in the Restored Files folder under your Home
folder.
If you prefer, you can easily tell Clickfree to restore your files to any place on your
computer’s hard disk that is convenient for you.
For details, see:
• “How do I let Clickfree restore decide what to restore and where?” on page 18
• “How do I change how Clickfree restores content?” on page 21
H
OW DO
I
LET
C
LICKFREE RESTORE DECIDE WHAT TO RESTORE AND WHERE
?
You can allow Clickfree to make the decisions about what to restore and to where, but you
need to confirm what Clickfree plans to do.
♦ To let Clickfree decide what to restore and to where:
1. Make sure that your computer is switched on and has finished starting up.
2. Log in, if that is what you normally do.
3. Connect the Clickfree Backup Drive to your computer by connecting one end of the
USB cable to the drive and the other end to a USB port on your computer.
Clickfree starts up just as it did when you used it to back up your content.
4. Wait for the Clickfree window to appear – this may take up to 60 seconds.
The Clickfree Welcome window appears with the countdown, just as it did when you
used it to back up your content.
But this time you are not going to allow Clickfree to start the backup.
Because you have backed-up content on your Backup Drive, the countdown window
now shows buttons at the bottom to allow you to
View Files and Restore files.
Copyright © 2009 Storage Appliance Corporation. 18