OmniSistem PR Solo 1200 - Manual (Page 12)

SOLO 1200 EN.doc 12/18
192-199 Reverse rotation speed 8
200-207 Reverse rotation speed 7
208-215 Reverse rotation speed 6
216-223 Reverse rotation speed 5
224-231 Reverse rotation speed 4
232-239 Reverse rotation speed 3
240-247 Reverse rotation speed 2
248-255 Reverse rotation speed 1
000-051 Clear
052-102 Prism 1
103-153 Prism 2
154-204 CTB
12 Prisms
205-255 CTO
000-120 0~540º index
121-127 Rotation speed 1
128-135 Rotation speed 2
136-143 Rotation speed 3
144-151 Rotation speed 4
152-159 Rotation speed 5
160-167 Rotation speed 6
168-175 Rotation speed 7
176-183 Rotation speed 8
184-191 stop rotating
192-199 Reverse rotation speed 8
200-207 Reverse rotation speed 7
208-215 Reverse rotation speed 6
216-223 Reverse rotation speed 5
224-231 Reverse rotation speed 4
232-239 Reverse rotation speed 3
240-247 Reverse rotation speed 2
13 Prism Rotation
248-255 Reverse rotation speed 1
14
Pan & Tilt Speed
（Extended function）
000-255 Adjust Pan&Tilt speed from fast to slow
15
Pan Fine (16Bit)
（Extended function）
000-255 Adjust Pan in 16Bit resolution
16
Tilt Fine (16Bit)
（Extended function）
000-255 Adjust Tilt in 16Bit resolution
17
Gobo Rotation Fine
（Extended function）
000-255 Adjust gobo rotation in 16Bit resolution
000-048 Reserve
049-080 Reset
081-112 Reserve
113-144 Turn lamp off
（stay 10 seconds）
145-223 Reserve
18
Control
（when extended functions
are invalid, shift this
channel to 15
th
channel.
）
224-255 Turn lamp on
（see remark below）
Remark:
If you intend to turn on/off the lamp via the 18
th
channel of the controller, don’t attempt to push the
slide bar of 18
th
channel to value 224-255 immediately after turning it off, or push the slide bar to
value 224-255 to wait it cooling. Under these 2 circumstances, the lamp can not be turned on. The