OmniSistem PR XL 700 - Manual (Page 15)

15/24
Fine
000-051 Clear
052-102 CTO
103-153 Frost
154-204 Prism 1
12 13 18 Prism / Frost
205-255 Prism 2
000-120 Prism index （ 0~540°）
121-127 Reverse rotation speed 1 (slowest)
128-135 Reverse rotation speed 2
136-143 Reverse rotation speed 3
144-151 Reverse rotation speed 4
152-159 Reverse rotation speed 5
160-167 Reverse rotation speed 6
168-175 Reverse rotation speed 7
176-183 Reverse rotation speed 8 (fastest)
184-191 Stop in current position
192-199 Rotation speed 1 (slowest)
200-207 Rotation speed 2
208-215 Rotation speed 3
216-223 Rotation speed 4
224-231 Rotation speed 5
232-239 Rotation speed 6
240-247 Rotation speed 7
13 14 19 Prism rotation
248-255 Rotation speed 8 (fastest)
000-020 White
14 15 20 Effect Wheel
021-255 Wheel full into beam gradually
000-125 Rotation speed from fast to slow
126-141 Stop in current position
15 16 21
Effect Wheel
Rotation
142-255
Reverse rotation speed from slow to
fast
16 17 22 Focus 000-255 Linearly focusing
23 Focus Fine 000-255 Focus in 16 precision
17 18 24 Zoom 000-255 From large to small
25 Zoom Fine 000-255 Zoom in 16 precision
18 19 26 Pan 000-255 Pan rotation 450°
20 27 Pan Fine 000-255 Pan rotation in 16 precision
19 21 28 Tilt 000-255 Tilt rotation 270°
22 29 Tilt Fine 000-255 Tilt rotation in 16 precision
23 30
Pan & Tilt
speed
000-255 Pan & Tilt speed from fast to slow
000-048 Reserved
049-080 Reset
081-112 Reserved
113-144
Lamp off ( stop in DMX value for 10 s)
145-168 Reserved
169-200
Lamp power reduced to 50%
201-223 Reserved
20 24 31 Control
224-255 Lamp on (See remark below)
Remark:
If you intend to turn on/off the lamp via the last channel of the controller, don’t attempt to push the channel to value
224-255 immediately after turning it off, or push the slide bar to value 224-255 to wait it cooling. Under these 2
circumstances, the lamp can not be turned on. The right operation is: turn it off---cool down---push the slide bar to turn it
on.