OmniSistem Beta 3 – DS1800 - Manual (Page 3)

This chapter explain device's features
Thank you very much for expressing your confidence in ELDER AUDIO products by
purchasing the DS1800 our high-quality Signal Distribution Splitter designed specifically
for both live and studio applications.
Please read the manual carefully and keep it for future reference.
There is a 'MODE' in the rear panel operating in 'Two Input Four Output ' or ' One Input Eight
Output'. In the mode of 'Two Input Four Output' ,the Signal of CHA & CHB will be split into
CH1 ~ CH4 & CH5 ~ CH8 to output ;In the mode of 'One Input Eight Output' ,the Signal of CHA will
be split into CH1~CH8 to output. There is an independent potentiometer for each channel out of 8
channels to adjust Separately with the maximum gain of 6dB.In addition, there is also setting up a
'LINK' output connector for CHA&CHB respectively to connect flexibly each other between devices.
3
INTRODUCTION
FEATURES
Work mode with 'Two Input Four Output', or 'One Input Eight Output'
Independent potentiometer for each channel to adjust
Full electric balance input and output connector
Link output connector
Concealed potentiometer knob to guarantee effectively the stable setting status of distributor.
Electrocircuit design for the super low Distortion & super low Noise.
Note:
1. In some Country or Area, Perhaps the form of power socket is different with the device.
but the method of connecting to device is similar.
2. Before operating the device, please make sure that Local AC Voltage in the range of the
device's requestion.