On Networks N150R Installation Guide - Manual (Page 7)

7
You can use an Ethernet cable (not included) or connect wirelessly.
• Use the Ethernet cable to connect your computer to an Ethernet
port on your router. If you are using a fixed IP address, be sure
the LAN port is set to DHCP before connecting. (The default IP
address is 192.168.1.1.)
• Or, connect wirelessly by using the preset wireless security
settings located on the label on the bottom of the router. (See the
Preset wireless security section for details.)
5. Launch a browser. If a web page does not open, close and reopen
the browser and type http://www.mywifirouter.com in the address
bar. Click the Setup tab and follow the steps to set up your router.
Preset wireless security
This product has a unique WiFi network name (SSID) and WiFi
network password (Network Key). The default SSID and network key
(password) are uniquely generated for every device (like a serial
number), to protect and maximize your wireless security. This
information is located on the label on the bottom of the product.
Note: When you configure the wireless
settings of this device, be sure to
select the correct country settings.
The country settings must be identical
to the country where the device is
operating.