Worklight set up, General operating instructions – Chicago Electric 98113 User Manual

Page 7

Advertising
background image

Page 7

SKU 98113

For technical questions, please call 1-800-444-3353.

TO pREVEnT

SERIOuS InjuRY

FROM ACCIdEnTAL

OpERATIOn:

Turn the power Switch to its

off position and disconnect

the Adapter Cord from its

electrical supply source

before performing any

inspection, maintenance, or

cleaning procedures.

Worklight Set up

Always place the Worklight on a

1.

clean, dry, flat, level surface capable

of supporting the weight of the Work-

light.
The work area must be free of direct

2.

sunshine and high temperature.
Keep children and pets out of the

3.

work area.
Route the AC/DC Adapter Cord (17)

4.

and Cigarette Lighter Adapter Cord

(16) along a safe route to reach the

work area without creating a tripping

hazard or exposing the Cords to pos-

sible damage. The Cords must reach

the work area with enough extra

length to allow free movement while

working.

General Operating Instructions

To Charge the Battery pack using the

AC/dC Adapter:

To charge the Battery Pack (12) of

1.

the Worklight, open the Charging

Socket Cover (11) on the tool and

insert the AC/DC Adapter Cord (17)

into the tool’s Charging Socket (7).

Make sure the Power Switch (10) is

in its “OFF” position throughout the

charging process. Then plug the AC/

DC Adapter into the nearest 120 volt,

grounded, electrical outlet.
IMPORTANT:

2.

The initial charge time

for the Battery Pack is

10 hours.

Thereafter, the charge times are

6

hours. do not overcharge the Bat-

tery to avoid damage to the Battery

and/or AC/dC Adapter.
The Battery Indicator Light on the

3.

Worklight will illuminate as follows:

Battery needs charging:

Right

side LED illuminates RED.
Battery is charging:

Left side LED

illuminates RED.
Battery is fully charged:

Left side

LED illuminates GREEN.

When finished charging, unplug the

4.

AC/DC Adapter from its electrical out-

let. Then unplug the Cord from the

Charging Input Port of the Worklight.

(See Figure A.)

FIGuRE A

pOWER SWITCH (10)

AC/dC AdApTER

CORd (17)

OR

CIGARETTE LIGHTER

AdApTER CORd

(16)

CHARGInG SOCKET COVER

(11)

Advertising