Coway MHS-U2201AX - Manual (Page 13)

Direction for use
/ Control panel instruction
Direction for use
Insert the power cord in a 120 V~ socket and press the soft touch button.
The appliance will start with bell sound.
The use of the water fully cooled after boiling or tap water stored for
a day will provide more comfortable humidity.
If the appliance is not to be used for a long time, remove the water in
the water tank and the reservoir thoroughly.
The humidity has a bad smell: The smell comes from chlorine
contained in tap water.
Using tap water stored for a day or water fully cooled after boiling
will reduce the smell.
Weak mist output or no mist output: The appliance may have a
weak mist output when cold water is used or water level is high.
Operate the appliance in strong mode for 30 seconds and then the
appliance will operate normally.
No mist output after cleaning: Foreign materials remain on the
nebulizer. Wash out the inside of the reservoir and the water tank
with clean water and wipe the surface of the nebulizer with a clean
brush.
In ‘Weak’ mode, a small amount of invisible water mist is sprayed
but the operation is normal.
Introduction
The default setting of the appliance is (rhythm humidification).
After inserting the plug, make the indoor environment comfortable by following
the instructions for operation.
If the appliance is not used, unplug the power cord and store the appliance.