ColdTech BC-50 - Manual (Page 4)

TEMPERATURE CONTROLS
The temperature controls are factory-set to maintain an average temperature of 38 F in refrigerators and 0
F in freezers. To maintain a different temperature, simply adjust the control knob located inside the unit.
To decrease the temperature (colder), turn clockwise. To increase the temperature (warmer), turn
counter-clockwise - see diagram
LOADING PRODUCT
The bin dividers have been installed at the factory for your conveniance. Feel free to reposition the
dividers as you see fit. To remove the bin dividers, simply push the divider towards the back wall until the
front of the divider is removed from the positioning holes. To install, position the divider to the desired
holes, making sure that the pressure spring is installed properly.
PAY CLOSE ATTENTION TO THE LOAD LIMIT STICKERS LOCATED ON THE INTERIOR
WALLS OF THE UNIT. DO NOT LOAD PRODUCT ABOVE THE LOAD LIMIT STICKERS OR
ABOVE THE TOP CROSS BAR OF THE BIN DIVIDERS. LOADING PRODUCT ABOVE THE
LOAD LIMIT STICKERS WILL HARM THE PERFORMANCE OF THE UNIT AND WILL VOID
WARRANTY.
-4-
CAUTION
Setting the temperature control to the
coldest setting may cause the evaporator
coil to freeze and ice up. This will eventually
result in a warmer cabinet temperature.
TEMPERATURE
READING
OFF
1
7
6
5
3
4
2
Temperatures range from
7 (coldest) to 1 (warmest).
Do not load
prduct above
the top
crossbar. Doing
so will harm the
refrigeration
and will void
warranty.