Operations and adjustments – Century Accel SE 5-Point 45100 User Manual

Page 12

Advertising
background image

OPERATIONS and ADJUSTMENTS

10

Recline / Upright Positions (fig. b):

Rear-facing

- MUST use Recline position.

Forward-facing - MUST use Upright position

Upright Position: Rotate stand out and push
into car seat (fig. b).

Recline Position: Pull stand out and rotate
into car seat.

Harness straps MUST move freely. Make sure
harness straps are not pinched by recline stand.

5-Point Crotch Strap Adjustment (fig. c):

• From bottom of car seat, pull crotch strap

clip out and remove clip from crotch
strap loop.

• From top of car seat, pull crotch strap out

and thread through desired slot. Make
sure red button is facing away from child.

• From bottom of car seat, re-attach clip to

crotch strap loop exactly as shown.

Overhead Shield Adjustment (fig. d):

• To adjust: Press button down and slide

shield to desired position closest to child.
Release button to lock shield into one of
5 positions.

NOTE: Shield does not need to contact
child when in closest position; harness
system restrains child.

Harness Straps (fig. a):

• To tighten: Pull lower belt tab.

• To loosen: Pull and hold upper belt tab

while pulling harness straps.

Harness Tie:

• To open: Press tab and pull apart.

• To close: Snap halves together. Make

sure harness tie is locked by pulling out
on each half.

Buckle:

MUST be in opening closest to but not under
child.

5-Point Models

• To buckle: Insert both tongues into

buckle. Pull up on tongues to be sure
they are locked.

• To unbuckle: Press red button and pull

tongues out of buckle.

Overhead Shield Models

• To buckle: Push tongue into opening.

Pull up on tongue to be sure it is locked.

• To unbuckle: Press red button, pull

tongue out of opening and lift shield
over top of car seat.

1

2

4

3

5

6

Advertising