Nformation – Cortelco CONF410PAK User Manual

Page 15

Advertising
background image

The Ringer Equivalence Number, which is used to determine the number of devices

you may connect to your phone line, indicates the amount of power that your telephone

draws from the telephone company line during ringing. If you have more than one tele-

phone (or other terminal device) connected to the telephone company line, you should

total the ringer equivalence numbers (REN s), and be sure that the total is not more than

five. Your telephones may not ring if the total is more than five. Also, in some rural

locations, your telephone may not ring if the REN total is more than three.

RESTRICTIONS You must not connect your telephone to coin-operated lines or party

lines.

INSTALLATION This model telephone must be connected to the telephone company

lines through a modular jack. The required USOC for the modular jack is RJ11C for

desk mounting and RJ11W for wall mounting. The USOC number is printed on the label

on the bottom of your telephone.

FCC

I

NFORMATION

Part 68 is a Federal regulation which requires equipment to be tested and registered

with the FCC prior to its connection to the network. This equipment complies with Part

68 of FCC rules. On the bottom of the telephone is a label that contains, among other

information, the FCC Registration Number and the Ringer Equivalence Number (REN)

for this equipment. You must, upon request, provide this information to your telephone
company.

IN CASE OF TROUBLE If your telephone should cause problems on the telephone

line, the telephone company can temporarily disconnect your service. The telephone

company must then notify and allow you to correct the problem.

This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-

ing two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

12

Advertising