Securing the ipaq to a fixed work surface, Securing the ipaq to a fixed work surface -13 – Compaq iPAQ User Manual
Page 52
Desktop Management
Quick Setup & User’s Guide
6-13
1. Insert the posts 1 on the Security Bar into the openings 2 on the rear of
the side panels.
Installing the iPAQ Desktop Security Bar
✎
If the metal extension (provided with the Security Bar) is inserted into the post that goes into the
right rear hole on the personal computer, the MultiBay eject button will be disabled. A drive
installed in the MultiBay cannot be removed until the Security Bar is removed.
The Security Bar may vary slightly from the one shown in the illustration above.
2. Install the tamper-proof Torx screw 3 with the small screwdriver 4 to
lock the Security Bar onto the Personal Computer. The Security Bar
features a cable lock provision 5 for an optional cable lock. For more
information, refer to “Installing a Compaq Security Lock” on page 14.
Securing the iPAQ to a Fixed Work Surface
Holes in the base of the personal computer allow you to bolt it to a desk or
other fixed surface.
QuickSetup_UsersGuide.book Page 13 Wednesday, May 30, 2001 9:36 AM