Cobra Electronics MARINE MR HH400 EU - Manual (Page 24)

Declaration of Conformity
and CE Marking
Nothing comes close to a Cobra ® 45
Specifications
44 English
Specifications
•
General
Number of Channels All International, Canadian and U.S.A.
Channel Spacing 25 kHz
Modulation 16 KOF3E
Input Voltage 7.2 VDC
Battery Life: Alkaline Batteries:
5% TX, 5% RX, 90% Stand-by 8 Hours @ 5 Watts, 10 hours @ 1 Watt
Current Drain:
Stand-by 40 mA
Receive 200 mA
Transmit 1.8 A @ High power 0.7 A @ Low
Temperature Range -20˚C to 60˚C
Radio Dimensions 139.7 mm x 55.9 mm x 35.6 mm
Radio Weight 499 g
Receiver
Frequency Range 155.500 MHz to 162.425 MHz
Receiver Type Double Conversion Super-Heterodyne
Sensitivity:
20 dB Quieting 0.35 uV
12 dB Sinad 0.30 uV
Adjacent Channel Selectivity -60 dB
Intermodulation and Rejection -60 dB
Spurious and Image Rejection -60 dB
AF Output 250 mW @ 8 Ohms
Transmitter
Frequency Range 155.500 MHz to 162.425 MHz
RF Output Power 1 and 5 Watts
Spurious Emissions -60 dB High -55 dB Low
Microphone Type Condenser
Frequency Stability +/-5 ppm
FM Hum and Noise -40 dB
Operating Your Radio Operating Your Radio
Declaration of Conformity
•
We, Cobra Electronics Europe Limited of
Dungar House
Northumberland Avenue
Dun Laoghaire
County Dublin, Ireland,
Declare under our sole responsibility that the product
Portable Marine Radio : MR HH400EU
MR HH300EU
To which this declaration relates, is in conformity with the
following standards and/or other normative documents.
EN60945 (2002) – EMC
EN60950-1 (2001) – SAFETY
ETSI EN301 178-1 (2000-08), ETSI EN301 178-2 (2000-08) – RADIO
We hereby declare that [all essential radio tests suites have been carried out and that] the above
named product is in conformity to all the essential requirements of Directive 1999/5/EC.
The conformity assessment procedure referred to in Article 10 and detailed in Annex [III] or [IV] of
Directive 1995/5/EC has been followed with the involvement of the following Notified Body(ies):
BABT, Claremont House, 34 Molesey Road, Walton-on-Thames, KT12 4RQ, UK
Identification mark:
The equipment will also carry the Class 2 equipment identifier.
The technical documentation relevant to the above equipment will be held at:
Dungar House
Northumberland Avenue
Dun Laoghaire, County Dublin, Ireland
(Name and address of EU representative)
Mike Kavanagh
(Name)
Managing Director of CEEL
(Title)
May 13, 2004
(Signature of authorized person) (Date)
0168
400-BR-F 6/23/04 2:12 PM Page 44