Troubleshooting – Craftsman 316.29271 User Manual

Page 17

Advertising
background image

17

TROUBLESHOOTING

NOTE:

For repairs beyond the minor adjustments listed above, contact your nearest Sears Parts &

Repair center (1-800-4-MY-HOME®) or other qualified service dealer for an adjustment.

C A U S E

A C T I O N

Oil fill plug/dipstick loose or missing o-ring

Tighten oil fill plug/dipstick, replace o-ring

C A U S E

A C T I O N

Old fuel

Drain gas tank and add fresh fuel

Improper carburetor adjustment

Take unit to a Sears or other qualified service dealer for

an adjustment

Fouled spark plug

Replace or clean the spark plug

Plugged spark arrestor

Clean or replace spark arrestor

Low power

Rocker arm clearance adjustment (see page 18)

Cultivator tines bound with dirt or grass

Stop the unit, switch the On/Off Stop Control to

STOP, clean and remove any debris binding the tines

C A U S E

A C T I O N

Empty fuel tank

Fill fuel tank with new fuel

Primer bulb wasn't pressed enough

Press primer bulb fully and slowly 10 times

Engine is flooded

Pull starter rope repeatedly with throttle control fully

engaged and with the choke lever in Position 3

Old fuel

Drain gas tank and add fresh fuel

Fouled spark plug

Replace or clean the spark plug

Plugged spark arrestor

Clean or replace spark arrestor

On/Off Control is in the OFF (O) position

Move switch to ON (I)

ENGINE WILL NOT START

ENGINE WILL NOT IDLE

ENGINE WILL NOT ACCELERATE

ENGINE LACKS POWER OR STALLS WHEN UNDER LOAD

C A U S E

A C T I O N

Air filter is plugged

Replace or clean the air filter

Old fuel

Drain gas tank and add fresh fuel

Improper carburetor adjustment

Adjust according to the Carburetor Adjustments section

C A U S E

A C T I O N

Old fuel

Drain gas tank and add fresh fuel

Improper carburetor adjustment

Take unit to a Sears or other qualified service dealer for

an adjustment

Dirty air filter

Clean or replace the air filter

Plugged spark arrestor

Clean or replace spark arrestor

C A U SE

A C T I O N

Spark plug gap is too small/close

Adjust gap to 0.025”

UNIT OCCASIONALLY HESITATES AT HIGH SPEEDS

SIGNS OF OIL AROUND OIL FILL PLUG/DIPSTICK

Advertising