CITIZEN CBM-710 - Manual (Page 7)

CBM-710/720 Service Manual
5
5. How to Remove the Auto Cutter Unit (720)
• Remove the printer mechanism from the main body.
• Remove 2 E3’s as shown in the figure.
• Pull out the shaft in the arrow direction for removal of the auto cutter unit. (Note that 2 spacers come off at the
same time).
Auto Cutter Unit
Spacer
Printer Mechanism
6. How to Remove the Operation Panel Board and PE Sensor Board
• Remove the upper cover and unfasten 2 tapping screws for removal of the operation panel board.
• Remove the printer mechanism and unfasten a screw for removal of the PE sensor board assembled with the PE
sensor holder. To remove the board only, remove the lug of the PE sensor holder.
Lug