Century LIFESTYLE SERIER PM-1722AC - Manual (Page 5)

To attach front wheel assembly:
• Hold wheel assembly upright.
• Tilt stroller slightly back and
push wheel assembly onto
leg until it locks in place.
Repeat for opposite leg.
CAUTION:
Pull on wheel assemblies to check that
they are locked in place.
4
ASSEMBLY continued
Front Wheel Assembly
To attach footrest:
• Snap footrest onto
stroller frame and
push up.
• Push footrest against legs,
then slide footrest down
until it snaps onto cross tube.
Footrest
To attach cup holder:
• Snap one end of cup holder
over stroller frame above
canopy.
• Rotate down to opposite
side and snap in place.
Cup Holder
Cross Tube
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping, DO NOT place more
than 3 lbs. (1.4 kg) in cup holder.
To secure rear support frame for canopy:
• Rotate canopy forward until
it stops.
• Check to be sure
Rear Support Frame
is locked in place.
If Rear Support Frame
is not locked, pull
forward until it locks.
Rear Support Frame for Canopy
Rear
Support Frame
• Check to be sure tabs on
bottom of footrest are
snapped onto Cross Tube.
Swivel Locking Tabs
To attach swivel locking tabs:
• Pull Bellow away from
swivel Post on front leg.
• Align grooves on Locking
Tab with grooves on Post.
• Slide Locking Tab over
Post until it snaps in
place.
Repeat for opposite leg.