Clarion DAH923 - Manual (Page 9)

DAH923
15
1. CeNET Cable
Orient the CeNET cable in the direction shown
in the figure and insert it until it is locked in
position. To remove the CeNET cable, pull it
by lightly grasping the slide cap A in your fin-
gers.
2. Digital Optical Fibre Cable
When you connect the digital optical fibre
cable to the RDI-OUTPUT terminal, firmly
insert it until it is locked in position. After con-
necting, fasten the cable using the included
cable clip 4.
Note:
Do not bend the digital optical fibre cable
through a loop smaller than 3cm in radius.
Doing so will greatly reduce performance.
Digital optical fibre cable
To remove the digital optical fibre cable, pull
it by lightly grasping the slide cap B of the
cable in your fingers.
3. DAB antenna
Connect a DAB antenna (sold separately) to
the DAB antenna input terminal 6.
3. DAB antenna (ZCP-102-700)
Connect the DAB antenna cable with the DAB
Blackbox interface cable coming from the
DAH923.
Note:
• Be sure to turn the main unit power off when the
DAB antenna cable is connected.
How to Make Wirings