Conair 06PM8032 - Manual

TO Replace BulB
cauTION: TuRN OFF pOWeR aND uNpluG.
allOW TO cOOl aT leaST 3 MINuTeS BeFORe
ReplacING BulB.
To order replacement: Call 1-800-3-CONAIR.
Ask for replacement bulbs #RP-35 and RP-34.
1. Remove screws from left and right sides of mirror
(Figure 1).
2. Carefully lift off the removable housing from the
half that is affixed to the stand.
3. Unscrew the old bulb and replace with new bulb
(Figure 2).
4. Carefully replace the removable half after locating
and aligning the screw holes to the fixed half.
5. Insert screws into screw holes and tighten.
IMpORTaNT
SaFeTY
INSTRucTIONS
WHeN uSING elecTRIcal applIaNceS, BaSIc
SaFeTY pRecauTIONS SHOulD alWaYS Be
FOllOWeD, INcluDING THe FOllOWING:
ReaD all INSTRucTIONS BeFORe
uSING THIS MIRROR
DaNGeR
–
TO ReDuce THe RISK OF
elecTRIc SHOcK: alWaYS uNpluG THIS MIRROR
FROM THe elecTRIcal OuTleT BeFORe cleaNING.
WaRNING
–
TO ReDuce THe RISK
OF BuRNS, elecTROcuTION, FIRe, OR INJuRY
TO peRSONS:
1. Unplug from outlet before putting on or taking
off parts.
2. This mirror should not be used by or near children
or individuals with certain disabilities.
3. Use this mirror only for its intended use
as described in these instructions. Do not
use attachments not recommended by the
manufacturer.
4. Never operate this mirror if it has a damaged
cord or plug, if it is not working properly, if it
has been dropped or damaged, or dropped into
water. Return the mirror to a service center for
examination and repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert an object into any opening.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products
are being used or where oxygen is being
administered.
9. To disconnect, turn all controls to the off position,
then remove plug from outlet.
10. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause fire.
11. Do not use on a soft surface such as a bed, where
openings may be blocked.
12. Turn switch to off position and unplug cord before
replacing light bulbs.
13. Do not place or store mirror where it can fall or be
pulled into a tub or sink.
14. If mirror falls into water, unplug it immediately.
Do not reach into the water.
15. Never use while sleeping.
16. Do not use bulb greater than 20 watts.
Use in any 120 volt, 60 hertz AC electric outlet
(ordinary house current). Do not use it in any
other electrical outlet. There is an electric outlet
in base. Do not plug any appliance over 12 Amps
into this outlet.
17. To protect against electrical hazards, do not use
while bathing or in the shower.
18. Unplug the mirror from outlet before cleaning. Do
not leave mirror unattended when it is plugged in.
FOR HOuSeHOlD uSe ONlY
SaVe THeSe
INSTRucTIONS
OpeRaTING
INSTRucTIONS
To reduce the risk of electric shock, this mirror has
a polarized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet reverse
the plug. If the plug does not fit, contact a qualified
electrician to install the proper outlet. Do not change
the plug in any way.
cauTION: Be SuRe DIRecT SuNlIGHT DOeS
NOT STRIKe MIRROR WHeN leFT uNaTTeNDeD;
ReFlecTeD SuNlIGHT caN cauSe FIRe.
1. Your lighted makeup mirror will rotate 360° so that
you can use either the normal, flat mirror or the 7x
magnifying mirror located on the opposite side.
2. Plug into any standard wall outlet (120 volt AC). To
turn on light, simply turn the dial on the base to
desired light settings.
3. After use, always turn switch to the off position,
and unplug from the wall outlet.
4. This mirror features an electrical outlet in the base.
Power ratings on the appliances plugged in this
electrical outlet should not exceed 12 amperes.
4. To store the mirror, see STORAGE for detailed
information.
SpecIal FeaTuReS
The lighted makeup mirror uses incandescent light
bulbs with special coating, reproducing shadow-free
lighting in four different settings: evening, home,
office and day.
Figure 1
Figure 2