Chauvet CH-175 - Manual (Page 5)

CH-175 User Manual 5 2004-09-20/13:36
Remove screws
Slide switch up or down
depending on your line voltage.
S
ETUP
Lamp
You will need to install the lamps prior to the initial operation of the fixture. Twelve JCDR 50W 120V
MR-16 halogen lamps are included.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L A M P I N S T A L L A T I O N
1) Remove the 2 screws on the lamp/gel-holder face
plate.
2) If replacing the lamp, remove old lamp first.
3) Slide the lamp out of the retaining clips.
4) Detach the lamp from the lamp socket and replace
with new lamp.
5) Replace lamp lamp/gel-holder face plate, align the
screw holes and fasten the screws.
6) No lamp alignment is necessary for this fixture
since the lamp is already optimized inside the
reflector.
Color Gels
The Color Bank includes color gels. Install them to create
color wash changes during the chase sequence.
1) Choose any one of the 4 colors and slide the color
gel into the open slot on the top side of the lamp/gel
holder.
2) When installing the Color Bank in a horizontal
orientation, make sure that the slotted end of the
lamp/gel holder is pointing upwards. This prevents
the gel from falling out over time.
3) When installing the Color Bank in a vertical
orientation and in a tight space, ensure the slotted side is not obstructed and that you maintain
the ability to insert a color gel.
Power
Your product is equipped with switch-selectable AC power
setting.
Warning! Verify that the power select switch on your unit matches the
line voltage applied. All fixtures must be connected to
circuits with a suitable Earth Ground.
•
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture’s specifications chart.
•
A fixture’s listed current rating is its average current draw under normal conditions.
gel
Top Side of
lamp/gel
holder