Chamberlain WD952LD User Manual

Page 26

Advertising
background image

26

ALL ONE-PIECE DOORS

1. Assemble the Door Arm:

• Fasten the straight and curved door arm sections

together to the longest possible length (with a 2 or 3
hole overlap).

• Make sure the garage door is fully closed. Connect the

straight door arm section to the door bracket with the
5/16"x1-1/4" clevis pin.

• Secure with a ring fastener.

• Pull the emergency release handle, disconnecting the

outer trolley from the inner trolley by pulling straight
down on the emergency release handle and sliding the
outer trolley back toward the motor unit.

• Connect the curved door arm section to the trolley using

the 5/16"x1-1/4" clevis pin and ring fastener.

NOTE: Adjusting the limits on the following page:

• The trolley will automatically connect. If not, review the

trolley lockout feature on page 31.

• When setting the up limit on the following page, the door

should not have a “backward” slant when fully open as
illustrated below. A slight backward slant will cause
unnecessary bucking and/or jerking operation as the
door is being opened or closed from the fully open
position.

Nuts
5/16"-18

Lock
Washers
5/16"

Ring
Fastener

Straight
Arm

Bolts
5/16"-18x7/8"

Door
Bracket

Clevis Pin
5/16"x1-1/4"

Curved
Door Arm

Door Arm

Closed
Door

Outer Trolley

Emergency Release Handle

Open Door

Door with
Backward Slant
(Incorrect)

Correct Angle

Inner Trolley

Inner Trolley

Outer Trolley

Figure 4

Figure 5

Advertising
This manual is related to the following products: