Curtis RCD 310 - Manual (Page 5)

. Press the Skip/Search button once during playback to skip to the beginning of
the next track. Continue to press this button to skip forward to higher numbered
tracks until you reach the desired track.
. Press the Skip/Search button once during playback to skip to the beginning
of the current track. Press twice to skip back to the beginning of the previous track.
Continue to press this button to skip backward to lower numbered tracks until
you reach the desired track.
. Hold the Skip/search or buttons during playback to rapidly search
forward of backward through the disc to locate a specific passage within a track that
you wish to bypass or to hear again.
. High speed search continues as long as the Skip/Search or buttons are
depressed. Normal playback resumes when the Skip/Search or buttons
are released.
NOTE: To begin playback of a disc on a specific track, wait until the player reads
the disc and displays the total track number, then press the Skip/Search or
buttons repeatedly until the desired track number is on the display. Press the
button to begin playback on that track.
Repeat Playback
This function allows you to repeat either a single track or the entire disc continuously.
. To repeat a single track - Select the track you wish to repeat and begin playback
on that track. Then press the REPEAT button once. The REPEAT indicator appears
in the display and the selected track will be repeated continuously until you cancel
the repeat function or press the Stop button.
.To repeat the entire disc - Press the REPEAT button until the “ REPEAT “ and “ ALL “
indicators appear in the display, then press the button to begin playback if
necessary. The entire disc will be repeated continuously.
To cancel Repeat Playback press the REPEAT button until the REPEAT indicator no
longer appears in the display. Repeat can also be cancelled by pressing the Stop
button, opening the CD door, or switching the FUNCTION Selector to TAPE
(OFF).
Skip/Search or Buttons
Programmed Playback
The CD Player in this unit has a 32 track programmable memory which allows you
to program up to 32 tracks on any disc for playback in any desired order. To program
tracks for playback the player must be in the Stop mode. If the disc is playing, press
the Stop button to stop playback and then proceed as follows:
STEREO HEADPHONE JACK
Connect the stereo headphones to the 3.5mm PHONES jack located at left top panel
for private listening. When the headphones are connected, the sound from the
speakers will automatically cut off. Before putting the headphones on your head,
reduce the volume to a low level. Then put the headphones on and gradually increase
the volume to a comfortable listening level.
(1) Press the PROGRAM button once. The PROG.
(Program) indicator begins flashing in the display
and the 01 appears indicating that you should
select the track that you wish to enter into program
memory number 1.
(2) Use the or buttons to select the first
track to be programmed. Example: Track 7. 07
indicator flashes in the display.
(3) Press the PROGRAM button again. This will store
track 7 into program memory number 1.The display
will now select the track to be entered into program
memory 2.
(4) Repeat steps (2.) And (3.) Until you have programmed up to a maximum of 32 tracks
into the program memory.
(5) To begin Programmed Playback press the button. The PROG Indicator stops flashing
and remains On . The player will begin to play the tracks in the order that you selected. , ,
PROG
PROG
PROG
Dynamic Bass Boost System (DBBS)
This special circuit provides bass response, especially at lower volume levels
where the bass has a tendency to disappear. Set the DBBS button to ‘ On ‘
to increase the bass. Set the DBBS button to ‘ Off ‘ for normal bass response.
Note: If you have the DBBS circuit On at high volume and you are listening to
music that contains very strong bass, you may experience some distortion. If
this occurs, reduce the volume or switch the DBBS button Off .
-9- -8-