Casio IT-2000 - Manual (Page 8)

8
2.3 Installation Method
This section describes the installation and setup procedures that must be performed before I/O Box
and PC operations are started. The following diagram shows a flow of the setup procedure.
Note:

For information about the installation procedure of the Upload/Download Utility refer to the
Upload/Download Utility Manual.

For information about the I/O Box setup refer to Chapter 2.3.1 “Setup of Satellite I/O Box”,
Chapter 2.3.2 “Setup of Master I/O Box”, and Chapter 2.3.3 “Setup of Satellite I/O Box to
Master I/O Box”.

For information about the setup of Upload/Download Utility environment refer to Chapter 2.3.4
“Setup of PC”.
Turn OFF the power of the
PC.
Set the DIP switch of I/O
Box.
Connect each cable between
I/O Boxes.
Connect cable between the
PC and I/O Box.
Connect AC adaptor for
each I/O Box.
Turn ON the power of all the
I/O Boxes.
Turn ON the power of the
PC.
Star up the
Upload/Download Utility
and set the environment.
(If Master I/O Box is used)
Mount SCSI Board in the PC and
install the SCSI driver
Install Upload/Download
Utility in the PC.
Fig.2.6 Installation flow of IT-2000