Crosley Radio Lancaster CR42 - Manual (Page 7)

AC
Polarized Plug
Turntable Operation
Turntable Operation
Turn the unit on by rotating the ON/OFF-VOLUME
ROTARY KNOB (13) located on the front panel to
the ON position.
1 Set the FUNCTION SWITCH (6) to PH. for
PHONO mode.
2 Set the SPEED CONTROL SWITCH (23) to
desire speed (33 1/3,45 or 78 rpm). Place the
record on the turntable.
3 Use the CUE LEVER (21) to raise the tone
arm off its rest. Pull the TONE ARM (22) slightly
to the right side until hear the "click" sound to
activate the turntable.
4 Move the tone arm over the record and use the
cue lever to lower it to the point you want the
record to start. Adjust the ON/OFF-VOLUME
ROTARY KNOB (13) to the desired listening
level.
5 At the end of the record, the TONE ARM (22)
will stop automatically. You must return it to the
TONE ARM REST (24) by hand.
7
1
Unwind the AC POWER CORD (27) at the back
of the unit and connect it to a power outlet.
2
Plug A/C cord into appropriate outlet.
3 This product is equipped with a polarized
alternating current line plug (a plug having one
blade wider than the other). This plug will fit into
the power outlet only one way. This is a safety
feature, If you are unable to insert the plug fully
into the outlet, try reversing the plug. If the plug
should still fail to fit, contact you electrician to
replace your obsolete outlet. Do not defeat the
purpose of the polarized plug.
Getting Started
Unpacking
1
Remove packing materials from unit.
Note: Save all packing materials.
2
Remove plastic bag covering radio.
3
Remove plastic safety cover from A/C plug.
4
Remove tie from A/C cord and untie antenna
wire on back of radio.
5
Open lid and remove styrofoam shipping
material from turntable.
6
Remove black tie-wrap from under the tone
arm.
7
Remove white protective needle cover by gently
pulling towards the front of the unit.
8
Untie the FM antenna and allow it to hang down
in a straight line for optimum FM reception. If
you have trouble tuning in an FM station, move
the external FM antenna for best reception. Do
no connect FM antenna to outside antenna.
6
Power Source Accessory: ADAPTER FOR 45 RPM
This adaptor allows you to play 45 RPM records.
1 Place the 45 RPM adaptor over the spindle.
2 Gently place your 45 RPM record onto the
turntable.
3 Follow the steps under turntable operation to
play your record.
Headphones Jack Operation
1
Connect headphones to the HEADPHONE
JACK (17)
2 Adjust volume to the desired listening level.
NOTE: When using headphones, the sound to the unit
speakers will be cut off.
The sound from all speakers is cut off.
Headphone Jack(17)
NOTE: Headphones not included with unit.