Clarity POWER C1000 - Manual (Page 7)

7
INSTALLATION
Warning: To prevent electrical shock, always remove the telephone line cord
from the wall jack before removing the cord from the telephone. Never leave the
line cord connected to the wall jack if it is not also connected to the telephone.
Select a Location
• This unit requires a modular phone jack.
• The unit should be located in an area where it is easy to see the lighted ringer.
• The unit can be used as a desk top phone or a wall mount phone.
Connecting the Clarity C1000 Phone
To install as a Desk Unit:
• Plug one end of the telephone line cord (long, flat) into the back of the
Clarity telephone.
• Plug the other end of the telephone line cord into the wall jack.
• Plug one end of the handset cord (coiled) into the bottom of the handset.
• Plug the other end of the handset cord into the jack located on the left edge of
the Clarity telephone.
• Place the handset in the cradle of the Clarity telephone.
• Avoid placing the unit where it will be exposed to excessive heat or humidity.
program redial signal flash
C1000 TM with Clarity ® Power TM
hold
abc def
jkl ghi mno
tuv
oper
pgrs wxyz
help
mute
boost
Flat cord here
Coiled
cord here
Note: If you are
plugging the phone
into an older 4-prong
jack, use an RJ11C
adapter.