Crystal Audiovideo SmArt - Manual (Page 3)

3
www.crystalaudiovideo.com
PPrreeccaauuttiioonnss
$ Before connecting the subwoofer unit to a power outlet, make sure that the operating
voltage of the local power supply is identical to that specified for the subwoofer.
$ Ensure that your amplifier is switched off, before connecting the speakers.
$ Turn off the subwoofer before connecting the input signal cable on its internal amplifier.
$ Make sure that you have connected the plus (+) and minus (-) terminals of each speaker
to the corresponding plus (+) and minus (-) terminals on the amplifier.
$ Make sure that all screws on the binding posts are tight enough, especially if you are
using bare speaker wires. A contact between bare speaker wires may cause short-circuit and
potentially damage your equipment.
$ Avoid the use of your amplifier in its power limits. Especially, in the case that your
amplifier is of low power, the continuous use in high power levels can cause distortion of the
signal, amplifier clipping and may cause severe damage to your speakers
$ Therefore, high power amplifiers are more preferable.
$ Do not drive speaker units with a continuous wattage exceeding the maximum power
indicated in this instruction manual for each speaker model.
$ Use the best speaker and interconnect cables you can afford.
$ Do not place loudspeakers in dusty or humid environments.
$ Avoid exposure to direct sunlight.
Caution: Your SmArt speakers come with electronically protected tweeter in order to avoid
problems of overheating that can cause their destruction.
However for even greater protection, avoid extremely high volumes in your amplifier that can
distort your sound signal or cause severe damage to your amplifier and your speakers.
ManualEnglish.qxd 13/04/2005 16:40 Page 3