Clarke D14 - Manual (Page 7)

10 Clarke ® Operator's Manual - D14 & D18
Figure 2
Figure 3
Figure 5 Figure 4
HOW TO ASSEMBLE THE MACHINE
To assemble the machine, follow this procedure:
1. Remove the brush housing, vacuum bags, hose,
wand, handle assembly, canister housing, and
tools from the carton.
2. Remove the canister housing and the brush
housing from the plastic bags.
3. Install the canister housing on the brush housing.
To install the canister housing, follow this proce-
dure:
a. Position canister housing over brush housing
(see figure 2).
b. Align pivot airway (A) and canister support
pivot (B) with openings (C and D) in bottom of
canister housing (see figure 2).
c. Lower canister housing completely onto brush
housing until pin clicks into place and latches
(see figure 3).
4. Install the handle assembly to the canister hous-
ing. To install the handle assembly, follow this
procedure:
a. Insert handle tube in the upper canister
housing (see figure 4).
b. Lower handle completely into canister housing
until mark on handle tube is below flush (see
figure 5, item A). This insures the handle is
properly seated.
c. Push handle latch into lock position (see
figure 5, item B).
C
B
A
D
A
B
Mark on
handle tube.