Automatic transmission fluid, Automatic transmission, Fluid -13 – Cadillac 2011 Escalade EXT User Manual

Page 375: Replacement, Vehicle care 10-13

Advertising
background image

Black plate (13,1)

Cadillac Escalade EXT Owner Manual - 2011

Vehicle Care

10-13

Automatic Transmission
Fluid

When to Check and Change
Automatic Transmission Fluid

It is usually not necessary to check
the transmission fluid level. The
only reason for fluid loss is a
transmission leak or overheating the
transmission. If a small leak is
suspected, then use the following
checking procedures to check the
fluid level. However, if there is a
large leak, then it may be necessary
to have the vehicle towed to a
dealer service department and have
it repaired before driving the vehicle
further.

Notice: Use of the incorrect
automatic transmission fluid
may damage the vehicle, and the
damages may not be covered by
the vehicle's warranty. Always
use the automatic transmission
fluid listed in Recommended
Fluids and Lubricants on
page 11‑7
.

Change the fluid and filter at the
scheduled maintenance intervals
listed in Scheduled Maintenance on
page 11‑2
.
Be sure to use the
transmission fluid listed in
Recommended Fluids and
Lubricants on page 11‑7
.

How to Check Automatic
Transmission Fluid

Notice: Too much or too
little fluid can damage the
transmission. Too much can
mean that some of the fluid could
come out and fall on hot engine
parts or exhaust system parts,
starting a fire. Too little fluid
could cause the transmission to
overheat. Be sure to get an
accurate reading if checking the
transmission fluid.

Before checking the fluid level,
prepare the vehicle as follows:

1. Start the engine and park the

vehicle on a level surface. Keep
the engine running.

2. Apply the parking brake and

place the shift lever in P (Park).

3. With your foot on the brake

pedal, move the shift lever
through each gear range,
pausing for about three seconds
in each range. Then, move the
shift lever back to P (Park).

4. Allow the engine to idle

(500 – 800 rpm) for at least
one minute. Slowly release the
brake pedal.

5. Keep the engine running and

press the Trip/Fuel button or
trip odometer reset stem until
TRANS TEMP (Transmission
Temperature) displays on the
Driver Information Center (DIC).

Advertising
This manual is related to the following products: