Philips MCM25037 - Manual (Page 14)

Radio Reception
Tuning to radio stations
Select TUNER source.
"TUNER” is displayed briefly.
Press BAND to select the desired waveband :
FM or MW.
ori ►) and Press down on
release button.
The display will show "SERRCH" until a radio
station with sufficient signal strength is found.
If a FM station is received in stereo, co is
shown.
Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press or I
or ►►) briefly and repeatedly until you have
found optimal reception.
Programming radio stations
You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number From this preset number
upwards, former programmed radio stations will
be overridden.The system will only programme
stations which are not in the memory already.
Press ▼ or A to select the preset number where
programming should start.
Note*
- If no preset number is selected, default is preset
( 1) and all your presets will be overridden.
Press PROGRAM for more than two seconds
to activate programming.
-♦ "RUTO" is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by MW. The last preset
automatically stored will then be played.
Manual programming
Tune to your desired station (refer to "Tuning to
radio stations”).
Press PROGRAM to activate programming.
-♦ prog flashes in the display.
Press T or A to allocate a number from 1 to 40
to this station.
Press PROGRAM again to confirm the setting.
prog disappears, the preset number and the
frequency of the preset station are shown.
Repeat the above four steps to store other
stations.
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
Press T or A until the desired preset station is
displayed.
Changing tuning grid (some versions only)
In North and South America the frequency step
between adjacent channels in the AM and FM
band are 10 KHz and 100 KHz respectively. In
the rest of the world this step is 9 KHz and 50
KHz. Usually the frequency step has been preset
in the factory for your area if not:
Select TUNER source.
Press ■ on the system for at least five seconds.
The display shows either "GRID 9” or
"GRID 10”.
Note*
- All preset stations will be lost and need to be
reprogrammed.
14
pg 001*020/M250/21*Eng 2.7.05 PM 3140115 29261