Chicco Car Seat - Manual (Page 11)

20 21
Use.Newborn.Insert.to.provide.
additional.support.and.ensure.
a.secure.harness.fit.for.smaller.
infants.
To Install Insert in Carrier
1 .Pull End of Buckle.through.
center.slot.in.insert.
2 .Pull Both Harness Straps.
over.and.around.side.panels..Push.
insert.firmly.into.bottom.of.carrier..
3 .When properly installed,
the.Newborn.Insert.and.harness.
should.look.like.drawing.
1
ONLY USE Insert with infants who weigh between 4 and 11
lbs. NEVER USE Insert if child weighs more than 11 lbs!
2
3
NEWBORN INSERT
To Adjust Canopy, grab.bow.on.both.
sides.and.rotate...Detach.fastener.tabs.
when.rotating.toward.front.of.carrier.
a .To Remove Canopy Fabric, pull.
fabric.away.from.Canopy.Mount.to.
expose.button..Press.button.on.canopy.
mount.to.release.end.of.bow...Slide.
canopy.fabric.off.bow.and.detach.
canopy.from.rear.of.pad..
To replace canopy, reverse.previous.
steps.
To extend/retract visor
b .To.retract.the.visor,.gently.push.it.
downward.and.allow.it.to.pop.up.under.
the.canopy...The.canopy.must.be.
extended.before.attempting.to.retract.
the.visor...
c .To.extend.the.visor,.gently.pull.
it.downward.from.underneath.the.
canopy.and.allow.it.to.pop.up.in.its.
extended.position.
CANOPY
a
The harness height may
have to be changed to fit your
child. Before using insert, read
the instructions on “Changing
Harness Height” and “Securing
Child in Carrier”
Top of insert should always be
BELOW the lower harness slots.
b
c
Release bow from canopy
mount on opposite side of carrier
if using carrier without canopy.