Celestron VistaPix 72212 - Manual (Page 10)

P.6
Play back
Auto shutter
Setting
Power off Play back
Auto shutter
Setting
Power off
MEMU MEMU
One erase
Erase all One erase
Erase all
ERASE ERASE
Yes
No Yes
No
ONE ERASE ONE ERASE
Yes
No Yes
No
ERASE ALL ERASE ALL
One erase
Erase all One erase
Erase all
ERASE ERASE
Play back
Auto shutter
Setting
Power off Play back
Setting
Power off
Auto shutter
MEMU MEMU
Play back
Auto shutter
Setting
Power off Play back
Auto shutter
Power off
Setting
MEMU MEMU
(Play back mode)
Press the Menu button , select "Play Back" and press OK button. Use
Up-Down button to select the pictures, press OK button to display
the picture in full screen. Press the Shutter button again to return to a menu
of nine thumbnail images.
Auto shutter mode(Timer)
Press the Menu button and select "Auto Shutter". Press the OK button
again to take an image automatically after 10 seconds.
(Setting mode)
Press the Menu button and select "Setting". Press the OK button
to enter the menu.
again
P.11
6-1.Windows 98SE / 2000 / ME / XP
6-2.Pentium 233MHz or higher
6-3.128MB SDRAM
6-4.Video(VGA) Card with 2MB of RAM for minimum 16-bit(High Color)display.
6-5.CD-ROM
6-6.USB port
6-7.600MB of free hard disk space.
6.System requirements
Installation of driver
Since VistaPix is a Mass Storage Device you can access captured images just as
if it were a hard drive, therefore no software driver is needed (See Mass Storage
Mode ).If using VistaPix with an older version of Windows 98SE it may be
necessary to install the software Driver.
B A
VistaPix PC with USB port
Erasing Pictures
Press the delete button while the thumbnail menu or full-screen image
is displayed. Select "Erase one" and press OK Button to erase a single
frame. Select "Erase all" and press OK button to erase all frames.