phil&teds bebe hs - Manual (Page 4)

3. Pull the sun hood forward to wrap around the handle. Attach the
domes on the inside to the handle.
This child seat can be installed into the appointed stroller as the
travel system.
INSTALLATION:
position the coupler on
the slot of the stroller, then press down the
coupler into the slot until you hear a “click”
signing the coupler is locked.
IMPORTANT : please make sure you hear
a “click”. You can try to pull up and forward
the child seat to confirm the coupler is
locked.
TAKING DOWN:
hold the child seat, lift
the red switch of the coupler with your
fingers then take the child seat out.
CARE OF YOUR PRODUCT
REMOVING THE COVER
The fabric cover can be easily removed for washing. Remove the
harness by gently feeding the harness straps through from the front to
the back of the seat, the crotch strap including the buckle should be
removed; turn the metal slide underneath the shell on its side and feed it
through the shell until the strap is free. Remove the cover and machine
wash at 30
°, line dry only.
To replace the fabric cover, follow reverse of the above.
CLEANING THE SEAT
The harness and plastic parts can be sponged with very mild detergent
and warm water. Do not use chemical cleansers, bleach or corrosives
on any part of the seat.