phil&teds evolution - Manual (Page 21)

Care Instructions /20
5.2 Refitting the 5-point harness
system and cover
• After washing, place the cover on the shell
(5-D).
• Loosen the bottom part of the cover and pull
the belt clip through the belt clip slot (5-E).
• Then pull the buckle clip through the buckle
clip slot (5-F).
• Thread the belts through the belt pads, head
pillow, the cover and the shell (5-G).
• Attach the shoulder belts to the belt yoke
and make sure that the red stitching on the
belt ends and the yoke are facing the shell,
(if this is not the case, your belts are twisted,
so untwist) then close the belt guard door.
(3-F to 3-H).
• Close the buckle (5-H) then fasten the cover
all around, also using the pins. Check the fit!