phil&teds tott XTR - Manual (Page 8)

FITTING THE CAR SEAT WHEN USING THE HARNESS
Make sure the seat belt has not become twisted. Also check that it is not
impeding the movement of covers or fit of the seat belt webbing in any way.
To release your child seat follow the above instructions in reverse order.
6
Step1
.
Place the child safety seat on the vehicle’s seat
ensuring it is firmly pressed against the car seat backrest
.
Step4
.
Then pull the lap belt between the two
red D
-
Ring in a suitable length so that this
lap belt can go around the front of the seat
.
Make sure the lap belt goes through the two
red belt guides
.
Please refer to the left
illustration
.
Finally tighten the lap belt
.
Step3
.
Thread the lap
belt goes from the two
red D- Ring by the
armrests.
Step2
.
Fasten the seat belt into the
seat belt buckle
.
Step5
.
Thread the diagonal belt through the upper
two red D
-
Ring
.
Then tighten all the diagonal belt
.
Then pull lap belt and diagonal belt to remove all
the slack and to tighten the seat belt
.
1
3
2
5
4
The finished installations is shown in picture 5
.
Installation Steps: 9-18kg
(approx. 9 months to 4 years)
DIAGONAL BELT LAP BELT