Pivotal Powersports Full Color Hi-Def LED Lighting Kit - Manual

Hi-Def Full Color LED Lighting Kit
Disconnect the vehicle’s battery and remove any body work that will have the LED light tubes located behind
them. Carefully mount the LED light tubes using double sided tape or plastic zip ties in the desired locations.
The box with the wires coming out of it is the control unit. Find a cool and dry place to mount the control unit,
making sure that the unit is away from any hot parts of the vehicle like the engine or exhaust, and not
exposed to water or rain.
Connect the red power wire from the control unit to
the positive side of the battery as shown in the
diagram to the left to the. Connect the black ground
wire to the negative side of the battery. The fuse
holder should be installed as close to the battery as
possible (making sure the fuse is removed until the
installation is complete.)
There is a separate black wire coming out of the
control unit, this is the remote control wire, and this
wire is not connected to anything. Do NOT connect this wire to any part of the battery or another wire. Also,
make sure that this wire is positioned as high as possible in the vehicle; this will increase the operating range
of the remote.
Once the control unit has been mounted and
connected to the battery, run the wires from the unit
to the individual tubes. It is recommended to run one
connection wire per tube. This makes expanding the k
much easier and insures full power to each light tube
it
.
eatly hide any loose wires making sure that the wires are not near any hot parts like the engine or exhaust.
inally, install the fuse and adjust the LED light tubes for maximum visibility on the vehicle, preferably in a
Remote Control Function
The included remote in the kit operate all functions of the LED lighting kit.
utton A – Cycles between all colors
erns
Copyright © 2007 Pivotal Powersports Corp. / All Rights Reserved
N
Using plastic zip ties will aid in this process. Reinstall any removed body work.
F
dark area like a closed garage. Then firmly secure them to the mounting area using double sided tape or
plastic zip ties. That is it, you are done! Enjoy your new LED Lighting Kit!
s
Pressing each button cycles the lights through its different colors, modes and
speeds. Press each button individually until the desired color / pattern /
speed appears.
B
Button B – Cycles between 5 flashing patt
Button C – Cycles between 5 flashing speeds
Button D – Turns the kit On and Off