Pivotal Powersports Remote Control - Manual

Remote Control Installation Instructions
Find a clean and dry location to mount the control unit. This remote control system is not
waterproof, so assure that the control unit and the remote handset transmitter does not
get wet. Attach the unit to the surface using double sided tape or plastic zip ties.
The blue color wire is the ANTENNA wire; it should not be connected to any other wire
and also be positioned as high as possible to increase the remote control range.
The black color wires are the GROUND wires; they should be connected to the power
source ground and the device’s ground that is being controlled.
The red wire is the POWER IN; it should be connected to the 12 volt power source.
The white wire is the POWER OUT; it should be connected to the 12 volt product that is
being controlled.
Press the ON or OFF buttons on the handset transmitted to activate or deactivate the
product you are controlling.
When the battery on the handset transmitter gets low, the operating range will decrease
as well. Replace the battery to remedy.
Copyright © 2007 Pivotal Powersports Corp. / All Rights Reserved