Pivotal Powersports Multi Function Remote Control - Manual

Multi-Function Lighting Remote Control Kit
Installation:
Find a clean and dry location to mount the control unit. This remote control system is not waterproof, so assure that the control unit
and the remote handset transmitter does not get wet. Attach the unit to the surface using double sided tape or plastic zip ties.
The BLUE color wire is the ANTENNA wire; it should not be connected to any other wire and also be positioned as high as possible to
increase the remote control range.
The BLACK color wire is the GROUND IN wire; it should be connected to the power source ground.
The RED wire is the POWER IN; it should be connected to the 12 volt power source.
The YELLOW wire is the POSITIVE OUT; it should be connected to the positive (power) wire of the LED’s that are being controlled.
The WHITE wire is the NEGATIVE OUT; it should be connected to the negative (ground) wire of the LED’s that are being controlled.
Operation:
There are 4 buttons on the remote handset. Each button performs a separate function, they are as follows:
1. Brightness Mode Control (8 Levels – dim to bright)
2. Strobe Mode Control (6 Levels – 2 to 7 flashes per strobe)
3. Fade Mode Control (1 Level – Fade In / Fade Out)
4. Turns System Off
Press the 1, 2, or 3 button on the handset to activate the LED’s you are controlling.
Press the 4 button to turn off the remote and the LED’s.
Battery:
When the battery on the handset transmitter gets low, the operating range will decrease as well. Replace the battery to remedy.
Replacement battery type: 27A / 12V.
Copyright © 2009 Pivotal Powersports Corp. / All Rights Reserved