PRG Mbox Director User Manual v3.6.1 - Manual (Page 33)

MBOX ® DIRECTOR USER MANUAL 27
Enabling Feedback
In order to view real-time feedback of MBOX Director scene content, either MBOX must be running in Fullscreen
mode (typical operation) or, if running in Window mode, the MBOX tab must be selected in the MBOX server window
as shown below.
If running in Window mode and the Mbox tab is not selected, dynamic movie content will not run on the
MBOX server or in the MBOX Director layer preview area!
Training Video: Mbox Media Server Training Video Chapter 6: CITP – Streaming Feedback & Thumbnails
Using Fullscreen Mode in Local Configurations
If MBOX Director and MBOX are running on the same computer, and you intend to use MBOX in Fullscreen mode, the
Fullscreen mode secondary display should be set to Output 2. This assumes that the MBOX is being used in Single
Output mode (not in one of the dual modes).
The Single Output Setup is configured at the Mbox Setup tab as shown below:
Mbox Tab Preview Area
Media Clip Preview Layer Content
Mbox Window Mbox Director Window