Pro Boat PRB3002 Quick Start - Manual


Push the antenna tube (Fig. 1) into the antenna mount.
Insert the antenna wire through the antenna mount and
into the antenna tube (Fig. 2) pushing it through until it
comes out the other end.
Plug the AC charger into the proper wall receptacle (110V).
Plug the battery pack into the charger and let it charge for
1 hour for the first time. Closely monitor the battery
temperature for the next hour. If the battery begins to warm,
stop charging immediately.
After running, or when the Mini-V slows noticeably, recharge
the battery pack for 1–2 hours for a full charge. Be sure
to charge the battery on a non-flammable surface. Over-
charging can damage the battery and cause injury or fire.
Never charge the battery while it is mounted in the Mini-V and
allow it to cool after each run.
Once the battery
is charged, apply
the supplied hook
& loop tape to the
hull (Fig. 3) and
battery (Fig. 4) as
shown. Confirm
that the receiver
switch is in the
"OFF" position
and install the
battery pack as
shown. Plug the
battery pack into
the ESC (Fig. 5).
Remove the transmitter battery cover by sliding the cover
from left to right. Install eight (8) AA batteries into the battery
holder. Pay close attention to the correct direction of the
positive (+) and negative (-) ends as marked in the tray. Once
all 8 batteries have been installed, reinstall the battery cover
by sliding it on from right to left.
Quick Start Guide Quick Start Guide
NOTE:
Step 1
Step 3
Step 4
Step 2
Before you start running your new Mini-V, it is absolutely necessary that you read
through all of the operating instructions to prevent unnecessary damage and get the
maximum enjoyment from your boat.
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5