Pro Boat PRB8060 - Manual (Page 4)

6 7
Failsafe
Failsafe servo positions are also set during binding. In the unlikely event that the
radio link is lost during use, the receiver will drive the servos to their preprogrammed
failsafe positions (normally neutral and straight steering). If the receiver is turned
on prior to turning on the transmitter, (no transmitter signal is present), all channels
have no output, to avoid operating or arming the electronic speed control. When the
transmitter is turned on, normal control is resumed.
Servo Reversing
Servo reversing is used to reverse the direction of the output of each channel. (e.g.,
a right steering command results in the wheels turning right). To reverse a channel,
switch the position of the correlating switch. The small screwdriver tool included with
your transmitter can be used to move the switch if necessary.
Reverse Switch - Throttle
Reverse Switch - Steering
Travel Adjust
Travel adjust is used to limit the maximum travel that each channel travels in each
direction. Travel adjust is independently adjustable in each direction. To reduce the
maximum travel in each direction, use the small screwdriver to rotate the
corresponding travel adjust dial counterclockwise. To increase travel in each
direction, rotate the corresponding dial clockwise.
Left Right Brake Throttle
Steering Trim
The steering trim dial is used to adjust the steering trim when the wheel is
centered. Rotating the dial causes the steering trim (the steering at rest position) to
be changed. Normally steering trim is adjusted until the boat tracks straight.
Steering Trim Dial
Throttle Trim
The throttle trim dial is used to adjust the throttle trim when the throttle stick is
released (neutral position). Rotating the dial causes the throttle trim (the throttle
position at rest) to be changed.
Throttle Trim Dial
Steering Rate
Steering rate (also known as dual rate) allows on-the-fly steering travel adjustments to
be made using the steering rate dial. Steering rate limits the amount of travel of the
steering servo. The steering rate cannot be greater than 100% and will never exceed
the amount of steering travel set with the travel adjust dials.
Steering Rate Dial