Clarke BEXT 300HV - Manual (Page 4)

Page 6 Clarke ® B EXT ® -100, 100H 150H, 300HV Operator's Manual
OPERATOR SAFETY INSTRUCTIONS (CONT.)
WARNING: Improper discharge of waste water may damage the environment and be illegal. The United
States Environmental Protection Agency has established certain regulations regarding dis-
charge of waste water. Also, city and state regulation regarding this discharge may be in effect
in your area. Understand and follow the regulations in your area. Be aware of the environmental
hazards of chemicals that you dispose.
CAUTION: To prevent damage to the power cord, do not move this machine over the power cord, instead,
lift the power cord over the machine. If the cord supplied is damaged, it must be replaced by
the manufacturer, its service agent or a similarly qualifed person in order to avoid the hazard.
CAUTION: To prevent damage to the power cord and hoses, do not use the power cord or hoses to pull
the machine.
CAUTION: To prevent damage to the machine avoid extreme temperatures.
CAUTION: To prevent damage to the machine do not let pump run dry.
SPECIFICATIONS Bext 100 Bext 100H Bext 150H Bext 300H
Bext 100H Detailer Bext 150H Detailer
Part Number 04156A 04157A / 04158A 04147A / 04152A 04148A
Solution Tank 9 gallon rotationally molded 13 gallon rotationally molded
Solutin Pump 100 psi demand pump 150 psi demand pump 300 psi demand pump
Vacuum Motor 5.7", 3 stage (2) - 5.7" 2-stage 7.2" 3-stage
Waterlift 140" 150" 140"
Easy Circuit Locator N/A Standard Standard Standard
On-board Heater N/A Standard Standard Standard
Wand Double bend twin nozzle polished stainless steel
Power Cable 25 ft. 12-3 hosp. (2) 25 ft. 12-3 hosp. grade plug
grade plug
Wheels (2) 8" non-marking & (2) 3" casters (2) 10" non-marking & (2) 2" casters
Hose 15 ft. crushproof vacuum and high pressure solution line
Low Moisture System Standard
Float Shut-Off Standard
Weight 69 lbs. 75 lbs. 90 lbs. 119 lbs.
Warranty Product Lifetime (10 years) on tank and mainframe; 1 year Parts and labor
• The Model B EXT ® -100, 100H, 150H or 300HV is an extractor for cleaning carpet. When used with a floor tool, the
machine applies cleaning solution to the carpet and removes the dirty solution and soil from the carpet.
• The extractor has controls to start the pump for the solution and the motor for the vacuum. The floor tools have controls
to release the solution.
• The extractor has a bypass pump. The pump runs when switched on, bypassing solution internally to keep pressure
even.The extractor starts when the solution lever on the floor tool is activated.
NOTE: When using the extractor to clean carpets, follow this procedure:
1. Do not walk on freshly cleaned carpets for at least four hours or until the carpet is dry to touch.
2. Do not remove aluminum or plastic pieces that have been placed under the legs of furniture until
the carpet is dry.
3. Do not allow children or pets to crawl or walk around on the damp carpet.
4. Vacuum right after the carpet is dry and then vacuum the carpet once a week as needed.
INTRODUCTION and MACHINE SPECIFICATIONS
INSPECTION: Carfefully unpack and inspect your new Extractor for shipping damage. Each unit is tested and inspected
before shipment. Any damage incurred is the responsibility of the carrier, who should be notified immediately.
CLEANING SOLUTIONS: We recommend liquid cleaning chemicals. A pH of 7-9 is strongly recommended to avoid
premature pump wear, which would voide the warranty.