Universal garage door opener (homelink®), Before you begin programming homelink, Electronics – Ram Trucks 2012 С/V - User Guide User Manual

Page 76: Universal garage door opener (homelink

Advertising
background image

Sound Horn With Lock

• To turn the horn chirp on or off when the doors are locked:

• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.

Then, press the PANIC button while still holding the LOCK button.

• Release both buttons at the same time.

Flashing Lights With Lock

• The turn signal lights flashing, when the doors are locked or unlocked, feature can

be turned on or off. To turn this feature on or off:

• Press and hold the UNLOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER

(HomeLink

®

)

• HomeLink

®

replaces up to three hand-held transmitters that operate devices such

as garage door openers, motorized gates, lighting or home security systems. The
HomeLink

®

unit is powered by your vehicles 12 Volt battery.

• The HomeLink

®

buttons that are located in the overhead console or sunvisor

designate the three different HomeLink

®

channels.

• The HomeLink

®

indicator is located above the center button.

Before You Begin Programming HomeLink®

• Be sure that your vehicle is parked

outside of the garage before you begin
programming.

• For more efficient programming and

accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink

®

system.

• Erase all channels before you begin programming. To erase the channels, place the

ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink

®

buttons (I and III) for up 20 seconds or until the red indicator flashes.

NOTE:
• Erasing all channels should only be performed when programming HomeLink

®

for the

first time. Do not erase channels when programming additional buttons.

• If you have any problems, or require assistance, please call toll-free 1–800–355–

3515 or, on the Internet at www.HomeLink.com for information or assistance.

ELECTRONICS

74

Advertising