Reliable ST3A - Manual (Page 2)

INSTRUCTIONS
ASSEMBLING THE STAND
To setup the Iron Press Stand correctly refer to the following
instructions:
1. Remove the stand from the carton and a small
plastic bag containing a metal bolt. You may
dispose of the packaging material, as required
by the law.
2. Place the stand in the upright position with the
feet on the floor. Open the legs of the stand so
that the unit can stand freely (see Fig. 1).
3. Swing the iron press base plate (A) over and
connect the support leg to the plate through
the opening slit (see Fig. 2). Lock the support
leg into position with lever (B) (see Fig. 3).
4. Take the wire clothes rack and connect to the
legs of the base as shown (Fig. 4).
5. Please remove/unscrew the Plastic bolt located
on the base of the Iron Press. Place the steam
press on the Stand plate. Now take the metal
bolt provided with the stand and screw it thru
the hole in the Stand, which is next to the
Velcro strap below, into the Iron press. (Fig 5),
Please note that you will need to align the hole
in the plate of the stand with the Hole in the
Iron press.
6. Finally, pass one end of the Velcro strap
through the unit in between the upper and
lower arms as shown ( Fig. 6) Secure tightly to
the other Strap. Now your Iron press is
completely secured to the Stand.
1
A
2
B
3
4
6
5