Rev-A-Shelf 4WTBD-Series - Manual

Drawer Size &
Mounting Positions
For Frame and Panel cabinet applications
Preparing drawer for hardware installation
6 mm bit with
stop collar
2.5 mm bit with
extension chuck
Pilot boring for
locking devices
Boring rear holes
for runner hooks
75°
Template T65.1000.02
Rear bracket
Important: Use of the T65.1000.02 template is recommended for accurate
location and angle of locking device pilot holes.
295.3750.01
612TH
Installation screw
T51.1700.04
Locking device
NOTE: For frame applications.
Minimum 3 screws per bracket.
All dimensions in millimeters
(Inch equivalents as noted).
Subject to technical modifications
without notice. Copyright 2009
17
.5
32
(1-1/4"
)
(1 1/
16
")
16 (5/8")
Fa ce frame rail
Face frame stil
e
5 (3/16”)
4 (5/32”)
39.5 (1-9/1 6")
295.3700.2x
12
Fa ce frame rail
Face frame stile
16
32
14 (9/16")
(1-1/4")
(5/8")
(3/32")
2
21
(13/16")
(15/32")
NOTE: Because material thickness may vary, the inside drawer width must
equal interior cabinet width minus 50 (1-15/16") for TANDEM to align and
run properly.
13 (1/2")
7 (9/32")
Ø6 x 10
(1/4" x 3/8")
bore for hook
Use T65. 1000.02
template for
accurate boring
11 (7/16")
33 (1-5/1 6")
Formula for calculating outside drawer width
For drawer side
thickness
19
(3/4")
18
(23/32")
17
(21/32")
16
(5/8")
15
(19/32")
Deduct from inside
cabinet width
11
(7/16")
13
(15/32")
14
(9/16")
17
(21/32")
19
(3/4")
for 2290B only
Min. top
clearance
6 (1/4")
Inside cabinet width
Drawer width
Opening
13 (1/2")
Bottom recess
Drawer side thicknes s
maximum 19 (3/4")
14 (9/16")
Bottom clearanc e
3
7
(1-7/
1 6")
25 (31/32")
Drawer height
maximum =
opening minus
20 (13/16")
Sy stem or
#7 profile
mounting
scr ews
Installation Instructions
TANDEM plus BLUMOTION 562F
Locking devices
Runner profiles
Rear mounting brackets (for frame applications)
INST-TDM562FB.11.09
Subject to technical modifications
without notice. Copyright 2009
Full extension concealed drawer runners
INDR 776.816.0 MA-192/1EN
For 19 mm (3/4") maximum
drawer side thickness
Drawer removal and installation
Height adjustment
1. Squeeze orange handles on
locking devices
2. Pull drawer straight out and up
1. Place drawer on runners and
close, locking devices will
automatically connect to runners
1. Press up on adjustment tab.
2. Push towards back of drawer.
Max. 3mm (1/8") rise of drawer.
Tilt adjustment
Rotate the tilt adjustment lever on the
rear of each runner profile to tilt the top
of the drawer front forward.
Tool free tilt adjustment +5 mm.
I-4WTSC-0812
Rev-A-Shelf, LLC.
2409 Plantside Dr.
Jeffersontown, KY 40299
(800) 626-1126
www.rev-a-shelf.com