Rev-A-Shelf 4WP Series - Manual

4WP Series
Installation Instructions
Step 1. Set Swing Out unit in cabinet with
3/4" spacer underneath for floor clearance.
Step 2. Swing Piano Hinge around to inside of
cabinet where unit is to be installed.
Step 3. Place the 1/4" spacers between unit and
center divider of cabinet. One at top and
bottom of unit
1/4" Spacer
Center Divider
Piano Hinge
Swing Out Unit
• Swing Out Unit
(25" tall version shown)
Over
Contents
1- Pantry Unit with Piano Hinge
1- Magnetic Catch and Strike Plate
4-Wire Fence pieces for top shelf (if needed)
8 - Wood plugs for top shelf (if wire fence is not used)
2- 1/4" spacers
1-Screw pack
Items needed for installation
Phillips Head Screw Driver
3/4" wood spacer
Note: If adequate clearance is available, install top shelf
wire fencing. If clearance is not available install
wood plugs into holes
Top View