Rev-A-Shelf 4231-Series - Manual

Installation Instructions for
Door Storage Utility Trays
Our Toll Free Customer Help Line is available for your
product questions during weekday hours: 800-626-1126
TOOLS REQUIRED: (Screw-In Clip Installation Only)
Soft Lead Pencil (For marking screw locations), Drill with
3/32” Diameter Drill Bit, #2 Phillips Screwdriver, tape measure
and any kind of tape.
Shelves can also be mounted to trimmable 26” or 58”
aluminum standards. (sold separately)
INSTALLATION INSTRUCTIONS FOR DOOR STORAGE UTILITY TRAYS
INSTRUCCIONES DE INSTALACIÓN DE BANDEJAS PARA ALMACENAMIENTO EN PUERAS
DIRECTIVES D’INSTALLATION DES PANIERS À USTENSILES MONTÉS SUR PORTE
I-4230-TRI-R
12400 Earl Jones Way • Louisville, KY 40299
800-626-1126 • www.rev-a-shelf.com
STEP 1
STEP 2
STEP 4
STEP 3
Screw-In Clip Installation - Snap one clip into the
slot at each end of the tray. Hold the shelf in place
and mark the screw locations using the upper holes
in each clip. Note: Before marking the screw loca-
tions, you may want to use a level or tape measure to
ensure that the tray is level.
Remove the clips from the tray by disengaging
spring hook as shown. Drill pilot holes at locations
marked in Steps 1. Wrapping tape 5/16” from tip of a
3/32” drill bit as shown. (Do not drill deeper than front
edge of tape). Mount clips at top holes using two (2)
1/2” x #6 screws (do not fasten securely).
With clips in vertical position, mark bottom hole
locations and drill remaining pilot holes (swing
clip to allow for drilling). Reposition the clips and
securely mount top and bottom of each clip using
two (2) 1/2” x #6 screws. Note: Use plastic screw
anchor or #6-32 toggle bolts (available at your local
hardware store) when installing Screw-In Clips on
wallboard, plaster or very thin material.
Position the tray on the clips and gently press
downward to engage spring lock. This completes
the installation of your Door Storage Utility Tray.
To install second Door Storage Utility Tray simply
repeat Steps 1-4.
Standard and Various Clips are available for
different installation applications.
DOOR STORAGE UTILITY TRAYS
SIZE:
1/2” x #6 SCREWS
NOTE: Two slots are provided at
each end of tray to allow for
varied surface locations.
SCREW-IN CLIP
06-07
10 3/4” length
13 3/4” length
19 3/4” length