Reznor UDAS in sizes 30 through 125 Option - Installation - Ceiling Suspension Kit - Manual

Form I-UD&APD Series-CS (11-14), PN 197096R1, Page 1
APPLIES TO:
Standard Power Vent Unit Heaters:
Models UDAP and ADP Sizes 30, 45, 60, 75, 100, 125
Separated Combustion Unit Heaters:
Models UDAS Sizes 30, 45, 60, 75, 100, 125
FORM I-UD&APD Series-CS (11-14)
Obsoletes Installation Form RZ-NA- I-UD-CS
Ceiling Suspension Kit,
Option CK22
Description/
Application
1) Along the front edge of the top of the heater cabinet, find three sheet-
metal screws. Remove all three and keep.
2) Position a suspension angle along the top edge of the cabinet as illus-
trated, lining it up with four holes. Using the three screws removed in
Step 1 and the one screw in the kit, attach the suspension angle to the
top of the heater.
Installation
Instructions
This kit includes a set of suspension angles that will allow the installer to
attach the heater directly to the ceiling without the use of hanger rods. The
suspension angles are designed to provide the required clearance above the
heater. These suspension angles may be used on Power Vented & Separated
Combustion Fan Type Model Sizes 30, 45, 60, 75, 100, and 125.
Each Option Package CK22, P/N 197094, includes:
WARNING: Improper installation, adjustment, alteration, service
or maintenance can cause property damage, injury, or death. Read
the installation, operation and maintenance instructions thoroughly
before installing or servicing this equipment.
Installation should be done by a qualified agency in accordance with the
instructions on this sheet and in compliance with all codes and requirements of
authorities having jurisdiction. Suspension of the heater is the responsibility of
the installer.
Before suspending the heater, check the supporting structure to be used to verify
that it has sufficient load-carrying capacity to support the weight of the unit.
Refer to the
illustration in
Figure 1, page 2.
Qty P/N Description Model
2 1000050 Suspension Angles APD
2 195496 Suspension Angles UDAP
1 195638 Sheetmetal Screw All
Weight - Standard Power Vent, Fan Type Unit Heater
Size 30 45 60 75 100 125
Weight (lbs) 54 59 67 72 96 101
Weight (kg) 24 27 30 33 44 46
Weight - Separated Combustion, Fan Type Unit Heater
Size 30 45 60 75 100 125
Weight (lbs) 54 59 67 72 96 101
Weight (kg) 24 27 30 33 44 46